PLEASE READ ALL THE INFORMATION 1ST , BEFORE YOU PURCHASE.
This is a Universal Torch stand. There may be modifications needed to adapt to your situation.
Choose your Torch. - Bethlehem , CC Ball&Swivel ( Requires SWIVEL ), CC Rack&Pinion , GTT or Herbie ( Requires SWIVEL ) , Nortel
Shaft is always 6" in Length w/ Tab for your Torch.
Holes for Torch are Pre-drilled , Mounting Hardware NOT included.
A swivel can be added for an even greater range of motion.
Swivel is Required for Herbert Arnold and CC torches w/o a Rack & Pinion mount. Or if you take the base off your torch and you loose the capability to move it freely , you will need the Swivel.
**Swivel Must be Ordered Separately , after your Torch Stand is in your cart.**
**Go to it immediately - Lathe Accessories**
Maximum capacity 25 lbs.
Swivel Instructions - Tighten Set Screws to Desired Tension and then move freely.
CAUTION – Do Not Over-tighten Swivel and occasionally add a drop of 3in1 or general purpose oil to lube swivel ! If binding occurs , loosen set screws if it doesn’t move freely.
This stand Mounts to your Lathe Carriage to allow a greater range of movement for your torch.
All Torch Stands will come with a T-Slot Adapter ( T-Slots ).
Which you will need to mount. Mounting Hardware NOT Provided.
( T-slots ) is the most universal Adapter. You can even mount it to a Bench under your Lathe , for Lathe's with No Fire Carriage , like the Beth. GL100.
The main arm slides in and out on stainless bearings and pivots side to side on a 5/8" Shaft.
Choose how Long you want the Shaft "post" to be on the Torch Stand , this is mounted under the Slider Box.
Choose 1" Shaft Length on Torch Stand for Lowest Mounting Position.
Choose 6" Shaft Length on Torch Stand for Higher , and Variable Mounting Positions.
Shaft may need to be cut to desired height. This can be done with a Hacksaw and a bit of sanding.
Picture is T-Slot Adapter with 1" Shaft on Torch Stand , mounted to an American Lathe Gator Carriage.
Choose your Lathe - American , Chinese/Indian , Litton , Sean , Other
PLEASE LET US KNOW WHICH MODEL LATHE YOU HAVE IN THE "NOTES" , AS YOU CHECK OUT. EXAMPLE - Gator , 5100 , EEL .....ect...
SEE Lathe Accessories to add any more Options to the Torch Stand.
Examples - Swivel , Drop Down , Side Marver Plate .......ect....
American Lathes , and Most Table Top Lathe's MAY need the Drop Down Adapter in order to put your Torch into the Correct Position.
AND IF YOU HAVE ANY QUESTIONS , PLEASE GIVE US A CALL 602-374-2447.
Or if we have any questions , we will give you a call....