Premium Lathe Torch Stand , for ALL Lathes

PLEASE READ ALL THE INFORMATION 1ST , BEFORE YOU PURCHASE.

This is a Universal Torch stand.  There may be modifications needed to adapt to your situation.

Choose your Torch. - Bethlehem , CC Ball&Swivel ( Requires SWIVEL ), CC Rack&Pinion , GTT or Herbie ( Requires SWIVEL ) , Nortel

Torch Shaft is always 6" in Length w/ Tab for your Torch. 

Holes for Torch are Pre-drilled , Mounting Hardware NOT included.

A swivel can be added for an even greater range of motion. 

Swivel is Required for Herbert Arnold and CC torches w/o a Rack & Pinion mount.  Or if you take the base off your torch and you loose the capability to move it freely , you will need the Swivel.

**Swivel Must be Ordered Separately , after your Torch Stand is in your cart.**

**Go to it immediately -  Lathe Accessories** 

Maximum capacity 25 lbs.

Swivel Instructions - Tighten Set Screws to Desired Tension and then move freely.

CAUTION – Do Not Over-tighten Swivel and occasionally add a drop of 3in1 or general purpose oil to lube swivel !      If binding occurs , loosen set screws if it doesn’t move freely.

The main arm is 19" in Length and slides in and out on stainless bearings via the Slider Box. The Shaft on the Bottom of the Slider box , allows the torch stand to pivot side to side on the 5/8" Shaft "post".   Choose Shaft Length.

Choose how Long you want the Shaft "post" to be on the Torch Stand , this is mounted under the Slider Box.

Choose 1" Shaft Length on Torch Stand for Lowest Mounting Position.

Choose 6" Shaft Length on Torch Stand for Higher , and Variable Mounting Positions.

Shaft may need to be cut to desired height.  This can be done with a Hacksaw and a bit of sanding.

This stand Mounts to your Lathe Carriage to allow a greater range of movement for your torch.

All Torch Stands will come with a T-Slot Universal Adapter ( T-Slots ).   

Which you will need to mount. Mounting Hardware NOT Provided.

( T-slots ) is the most universal Adapter.   You can even mount it to a Bench under your Lathe , for Lathe's with No Fire Carriage , like the Beth. GL100.  

Picture is T-Slot Adapter with 1" Shaft on Torch Stand , mounted to an American Lathe  Gator Carriage.

Choose your Lathe - American , Chinese/Indian , Litton , Seam , Other

PLEASE LET US KNOW WHICH MODEL LATHE YOU HAVE IN THE "NOTES" , AS YOU CHECK OUT.  EXAMPLE - Gator , 5100 , EEL .....ect...

SEE Lathe Accessories to add any more Options to the Torch Stand.

Examples - Swivel , Drop Down , Side Marver Plate .......ect....

American Lathes , and Most Table Top Lathe's MAY need the Drop Down Adapter in order to put your Torch into the Correct Position.

AND IF YOU HAVE ANY QUESTIONS , PLEASE GIVE US A CALL 602-374-2447.

Or if we have any questions , we will give you a call....

This is a Universal Torch stand.  There may be modifications needed to adapt to your situation.